So sorry for the delay in posting new info. As I said last time, I'd had an accident while working on the Excalibur card board mock up which resulted in a destroyed model. It was a bit of a bitter-sweet kind of screw up since on the one hand, I had to start over on the mock up. But on the other hand I specifically chose to work in cardboard for this part of the project specifically so that if I had a screw up, it wasn't going to cost me $20 in materials. So... I guess it is like planning for a problem and having the problem occur. Yeah you're prepared and ready for it, but you still had a problem. So.. yeah.
Anyway I have been working on rebuilding the mock up and been making good progress. Having built it once already I can zip through a lot of it while also correcting some mistakes I made the first time around.
Here you can see I'm built the mark 2 model up to the level of the previous version at the time it was destroyed. The main body is actually stronger then the first version and has cleaner joins between the various parts.
So that's it? I got back to where I was last week and now I'm done with this post?
Yeah, not so much. I have started working on the next sections. Firstly there's the cannon mounting under-carriage, the part that holds the reaper cannons in Wing Commander 3.
You ever start to work on something and think it'll be super-easy and you can just zip right through it, but once you start working on it, you find out it's actually way more difficult then you thought it'd be? Well, that was this part in a nutshell. Cut 2 side parts so they line up with the under side of the body and the forward boom, what's so hard about that? Simple, I have no formal 3D design experience or training. So because of that I had to re-cut the sides a couple times after I found I had not measured properly.
For detail and variation I took a pencil and darkened the inner spaces of the under carriage where the reaper cannons would be placed.
And then, there is the power-plants... er missile bays.... er... whatever the boxy shapes on the sides of the main body are. This proved to be more challenging then it first appears.
The initial shape was easy enough to accomplish, measure and cut the upper and lower sections as they appears in the line art. I had to do some interpretation to make the side and inner-section. There's little enough I can say about the sides that would really help any aspiring crafters. I had to estimate my measurements, cut a piece and test it. Find out I was wrong, and try to correct it with a new version.
No the real challenge was the scoop intake covers. See, it's an angle that extends in 2 dimensions, backwards relative to the body, and outward relative of the body. It's something that isn't immediately apparent from the 2D line art. So I had to cut and fit the ram scoop cover about 6 times before I got a sizing that fits.
Anyway I have been working on rebuilding the mock up and been making good progress. Having built it once already I can zip through a lot of it while also correcting some mistakes I made the first time around.
So that's it? I got back to where I was last week and now I'm done with this post?
Yeah, not so much. I have started working on the next sections. Firstly there's the cannon mounting under-carriage, the part that holds the reaper cannons in Wing Commander 3.
And then, there is the power-plants... er missile bays.... er... whatever the boxy shapes on the sides of the main body are. This proved to be more challenging then it first appears.
No the real challenge was the scoop intake covers. See, it's an angle that extends in 2 dimensions, backwards relative to the body, and outward relative of the body. It's something that isn't immediately apparent from the 2D line art. So I had to cut and fit the ram scoop cover about 6 times before I got a sizing that fits.
0 comments:
Post a Comment